Quick answer: to trim a video without re-encoding, the tool copies the original video and audio data between your start and end points instead of compressing them again. It is almost instant and keeps 100% of the original quality and resolution. The catch: the cut can only start on a keyframe, so the clip may begin a moment earlier than you chose. In the video trimmer, switch on Fast cut to trim this way.
Most online trimmers quietly re-compress your whole clip, even if you only removed two seconds. That takes time, and every re-encode loses a little detail. If you just want the boring start and end gone, there is a better way.
Re-encoding vs. lossless cutting
| Normal trim (re-encode) | Fast cut (no re-encode) | |
|---|---|---|
| Speed | Takes a while on long videos | Seconds |
| Quality | Very good, but a new encode | Identical to the original |
| Resolution | Up to 1080p | Original, including 4K |
| Cut accuracy | Exact, to a tenth of a second | Starts at the nearest keyframe before your start point |
| Format | Fresh MP4 that plays everywhere | Same codec as the original |
What is a keyframe, and why does it matter?
Video files don’t store every frame as a full picture. That would make them enormous. Instead they store a full picture (a keyframe) every second or few seconds, and in between they only store what changed. A frame in the middle depends on the keyframe before it.
That is why a lossless cut can’t start just anywhere: if it began between keyframes, the first frames would have nothing to build on and would show up as grey blocks or a frozen image. So the cut moves back to the previous keyframe, which is usually within a second or two. The end of the clip is not affected in the same way.
How to trim a video without re-encoding
- Open the SizeMyVideo trimmer and drop in your video (MP4, MOV, MKV, WebM or AVI, up to 1 GB).
- Drag the two handles to the part you want to keep, or type the start and end times. Press Play selection to check it.
- Turn on Fast cut.
- Press Trim video and download the clip. It is ready almost immediately.
When to use Fast cut, and when not to
Use Fast cut when:
- You are removing dead time at the start or end of a recording.
- The video is 4K or high bitrate and you want to keep every detail.
- The video is long and you don’t want to wait.
Use a normal trim when:
- The cut has to be frame-exact, for example a clip that must start right on a word or a beat.
- The original is in a format that some devices can’t play, such as MKV or HEVC. A normal trim gives you an MP4 that plays everywhere. (More on that in converting MOV to MP4.)
- You also need a smaller file. In that case trim first, then run the clip through the compressor.
Frequently asked questions
Why does my trimmed clip start a second early?
Fast cut started at the nearest keyframe before your chosen start. Turn Fast cut off for a frame-exact start.
Is a lossless trim really zero quality loss?
Yes. The picture and sound data are copied, not decoded and encoded again, so the frames are bit-for-bit the same as in your original.
Can I trim the middle out of a video?
The trimmer keeps one continuous section. To remove a part from the middle, trim the two sections you want to keep separately, or use the splitter to cut the video into parts.
Does it work on a phone?
Yes. It runs in the browser on iPhone and Android. See how to trim a video on your phone without an app.